If this is the case, then the NVRAM and MFP board will have to be replaced as a set.ģ. If this is done, and the NVRAM is replaced, the corrupt data that was just backed up will be transferred to the new NVRAM. This will take the corrupt NVRAM image and back it up to the MFP board. WARNING: If a corrupt NVRAM is suspected, DO NOT perform the NVRAM Data Backup. There are approximately 30 registers that can be corrupt, so the above procedure may have to be done as much as 30 times. What this procedure does is take a good image of the NVRAM off the MFP board (created when you performed the NVRAM Data Backup) and restore it to the NVRAM. A NVRAM Data Restore procedure can be used to address these codes: Mostly these codes happen when updating firmware. NVRAM trouble codes (C-D3xx codes) can occur at any time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |